Kenwood TKR UHF Base Station/Repeater, MHz, W. Includes : DC Power Cable, rack handles and hardware, DC power supply adjustable. VHF/UHF FM Repeater-Base Units. General Features. 19″ Rack Mount Design; Primary DC Input Connector; Auto-Switched Back-Up DC Input Connector. TKR contains many Programmable Functions tabled below. Programmable cable, E, which is available from the KENWOOD parts center.
|Published (Last):||14 December 2011|
|PDF File Size:||2.35 Mb|
|ePub File Size:||17.91 Mb|
|Price:||Free* [*Free Regsitration Required]|
I have tried many other models of controllers and found that the RLC-4 and the Kenwood mated together are a perfect match. Power and receivers have been checked. Includes item s seen in picture s. We matched the TKRs and several s to the Arcom controller. No failures to date in a busy continuous duty system. If you have any questions feel free to message me. Decent appearance, not beat up or dirty.
Morse code IDs are attenuated if the repeater is in us All of the repeaters are the TKRK. If the selection was available on this site for a better rating I would rate it at a 4. I have given kensood a 4 as I have only owned it for a few months, so it has very low run time, but so far it has performed well.
Being a Kenwood Dealer i make special deals for clubs and hams. After looking to buy a used machine and rebuild, I decided to just buy a new one.
Skip to main content. Sure, the repeater has a basic controler and it does a terrific job. My Subscriptions Subscriptions Help. It was slightly modified to work in the HAM band, but the front end was adjusted to compensate.
What you see is what you get. Recently removed from active service in Ham bands. These cables are not fused. However i recomend if your using them in Ham use spend the extra and use an external controller FCC Requirement to remotely control the repeater.
The exciter is operating 10 watts out into my PA delivering a nice signal with outstanding audio!
This page was last updated: You can disable it via the internal controller but if someone is jamming your repeater its nice to come in on a full duplex link or external receiver.
I have more than 18 of these repeaters in HAM repeater use. See each listing for international shipping options and costs. Make a very good GMRS repeater. This has been tested and working. Our club has a TKR V2. The repeaters can be setup ready to go with or without a controller. No duplexer included a Kenwood UHF repeaters removed from service. Digital Paging Encoder Input.
You can always add an outboard controller to the included serial port. An all around great machine. The repeater has been installed in a high RF zone with great performance giving me dBm RX out of the box.
The controller is very basic, but it will satisfy the minimum requirements. Also shop in Also shop in.
You can toggle the Kenwood outbound tone to drop when inbound tone drops – nice feature. As this item is not new, its is not covered by any warranty, kewnood is being sold as is. Contact the site with comments or questions. All new quality materials. Sorry if this is an inconvenience. Up for sale is: